Drenagem e reabastecimento do fluido da transmissão

Automatic Transmission/Transaxle – Vehicles With: 307-01- 307-01- 6-Speed Automatic Transaxle - 6R80 GENERAL PROCEDURES 5. Install the transmission fluid pan and tighten the bolts in a crisscross pattern. ‡ Tighten to 12NM E128907 Refill WARNING: The transmission fluid fill plug is located near the exhaust system. The exhaust will be extremely hot during this procedure. CAUTIONS: This procedure contains the air purge steps required to purge air from the transmission fluid cooling system. This procedure is NOT intended for use with the Transmission Fluid Level Check. The vehicle should not be driven if the transmission fluid level is low as internal failure could result. The use of any other transmission fluid than specified can result in the transmission failing to operate in a normal manner or transmission failure. NOTE: If the transmission starts to slip, shifts slowly or shows signs of transmission fluid leaking, the transmission fluid level should be checked. NOTE: Here is an overview of the Transmission Fluid Drain and Refill procedure. 1. NOTE: The transmission will need 3.3L (3.5 qt) of transmission fluid added to the transmission as an initial fill if: th•e transmission has been overhauled. a• new mechatronic assembly has been installed. th•e transmission fluid pan or transmission fluid filter have been removed. Using the Transmission Fluid Fill Tube, add 3.3L (3.5 qt) of transmission fluid to the transmission through the transmission fluid fill hole. For additional information, refer to Adding Additional Transmission Fluid in this procedure.transmission fluid 2. Check the transmission fluid level cold. ‡ The vehicle is safe to drive if the transmission fluid is in the cold level range 32°C-43°C (90°F-110°F). ‡ Using the scan tool and with the engine running, place the selector lever in each gear position and hold approximately 5 seconds. Place the selector lever in PARK, with the engine at idle (600-750 rpm). 3. Separate the transmission fluid level indicator from the transmission fluid fill plug. E129418 4. Wipe the transmission fluid level indicator clean. Reinstall the transmission fluid level indicator only back into the transmission fluid fill plug hole to check the transmission fluid level. Repeat this until a consistent reading is established. E129425