Ajuste da válvula proporcionadora com sensor de carga do freio

Brake System - General Information 206-00-3 206-00-3 GENERAL PROCEDURES Brake Load Sensor Proportioning Valve Adjustment(12 136 0) 1. Place the unloaded vehicle on level ground. Unloaded: Fuel tank is full. Jack and tools are in designated position. 2. A change of 5 mm (0.20 in) in dimension L results in a change of the following. DCF411ZWB004 3. Adjust main spring dimension L between the LSPV and the adjustment link loosening and repositioning the LSPV. ‡ Decrease dimension L if the fluid pressure is low. ‡ Increase dimension L if the fluid pressure is high. 4. Specification Dimension L Type Dimension x (mm {in}) 4x2 (except Hi-Rider) 166.0–173.0 Without 4W-ABS (5.808–6.082) Hi-Rider, 4x4 Without 184.5–191.5 4W-ABS (6.910–7.185) 5. Tightening the nut. Specification 11.4–15.6 Nm (1.90–2.59 kgfm, 13.8–18.7 ftlbf). 6. After adjustment, recheck the fluid pressure. Type Change (kPa {kgf/ cm2, psl}) 4x2 (except Hi-Rider) 625 (8.7, 123) Without 4W-ABS Hi-Rider, 4x4 Without 510 (11, 154) 4W-ABS If not as specified, replace the LSPV as a component.