Drenagem e reabastecimento do fluido da transmissão

Automatic Transmission/Transaxle – Vehicles With: 307-01-12 307-01-12 6-Speed Automatic Transaxle - 6R80 GENERAL PROCEDURES 5. Use a Rubber Tip Air Nozzle to apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/ pressure hose from the Transporter Fluid Evacuator/ Injector. Transmission fluid will immediately start flowing out of the Transporter Fluid Evacuator/Injector into the transmission. 307-D465 100-D009 E129424 6. NOTE: Do not overfill the transmission. The transmission fluid level must be at the upper level of the crosshatch mark. Reinstall the transmission fluid level indicator only back into the transmission fluid fill plug hole to check the transmission fluid level. Repeat this until a consistent reading is established. 307-D465 E129423 7. Using the scan tool, verify that the TFT is between 80ºC-85ºC (176ºF-185ºF). The transmission fluid level must be at the upper level of the crosshatch mark. E129428 8. NOTE: If the transmission fluid is over full, follow the steps for Removing Transmission Fluid in this procedure. Install the transmission fluid fill plug. ‡ Tighten to 35 Nm E128906 Removing transmission fluid NOTE: To get an accurate transmission fluid level reading the engine should be idling (600-750 rpm) in PARK. 1. If the transmission is overfilled, transmission fluid must be removed to the correct level. Use the Transporter Fluid Evacuator/Injector