Motor

Engine – 2.2L Duratorq-TDCi (88kW/120PS) - Puma/2.2L Duratorq-TDCi (96kW/130PS) 303-01B-102 303-01B-102 - Puma/2.2L Duratorq-TDCi (110kW/150PS) - Puma ASSEMBLY 24.Special Tool(s): 205-069, 205-070 205-070 205-069 TIE0034799 25.NOTE: Do not fully tighten the crankshaft position sensor bracket retaining bolts at this stage. x2 x2 E87418 26.NOTE: After installation do not move the special tool. Special Tool(s): 303-391 303-391 TIE0034801 27.Rotate the crankshaft until piston No. one is approximately 10 mm before top dead center (TDC). Special Tool(s): 205-069, 205-070 28.Zero the dial indicator gauge. 205-070 205-069 TIE0034799 29.Mark the position on the flywheel primary mass. Special Tool(s): 303-391 303-391 TIE0034802 30.NOTE: Rotate the crankshaft counterclockwise. 1. Rotate the crankshaft until the piston No. one achieves zero on the dial indicator gauge. 2. Mark the position on the flywheel primary mass. Special Tool(s): 303-391 31.Repeat the previous steps to make sure that the marking is correct. 303-391 TIE0034803 32.NOTE: The middle of the markings is TDC.