Motor

Engine – 2.5L Duratec-HE (122kW/165PS) - MI4 303-01A-95 303-01A-95 ASSEMBLY NOTE: Mating surface should not have traces of oil to improve the adhesion. Material: Silicone Sealant LB (WSE-M4G323-A4 / 2U7J-M4G323-AA) sealant 3mm E131616 42.Install the oil pan. Torque: 25 Nm 7 12 3 2 6 11 13 4 8 10 1 5 E131625 43. ‡ Install the cylinder head alignment dowels. ‡ Dowels must be fully seated in the cylinder block. A0032441 44. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges that make leak paths. Use a plastic scraping tool to remove all traces of the head gasket. NOTE: Observe all warnings and cautions and follow all application directions contained on the packaging of the silicone gasket remover and the metal surface prep. NOTE: If there is no residual gasket material present, metal surface prep can be used to clean and prepare the surfaces. ‡ Clean the cylinder head-to-cylinder block mating surface of both the cylinder head and the cylinder block in the following sequence. 1. Remove any large deposits of silicone or gasket material with a plastic scraper. 2. Apply silicone gasket remover, following package directions, and allow to set for several minutes. 3. Remove the silicone gasket remover with a plastic scraper. A second application of silicone gasket remover may be required if residual traces of silicone or gasket material remain. 4. Apply metal surface prep, following package directions, to remove any traces of oil or coolant, and to prepare the surfaces to bond with the new gasket. Do not attempt to make the metal shiny. Some staining of the metal surfaces is normal. 45.Apply silicone gasket and sealant to the locations shown. A0032324