Auxílio de estacionamento
Parking Aid

Texto da página
Link desta página: https://ranger.mbrace.com.br/oficina/1226
Imagem: https://ranger.mbrace.com.br/img/oficina/1226.webp
413-13-7
Parking Aid
413-13-7
DESCRIPTION AND OPERATION
Front parking aid speaker
E89774
The front parking aid speaker is located within the
instrument panel behind the instrument cluster.
For additional information, refer to: Front Parking
Aid Speaker (413-13 Parking Aid, Removal and
Installation).
Rear parking aid speaker
E89773
The rear parking aid speaker is used to indicate
failure modes within the front and rear parking aids.
If the rear parking aid speaker becomes defective,
the front parking aid speaker will then be used to
indicate failure modes.
For additional information, refer to: Rear Parking
Aid Speaker - 4-Door (413-13 Parking Aid,
Removal and Installation).
Parking aid module
E89772
The parking aid module has three connectors which
provide for power, ground and CAN bus
connections, front and rear parking aid sensors,
parking aid switch, LED and parking aid speakers.
The medium speed CAN bus connections provide
for the receipt of the following information from
other systems:
ABS (anti-lock brake system) module - Road
speed signal
Generic electronic module (GEM) - Reverse
gear engaged signal, vehicle configuration
parameters, carmode and powermode
Electronic parking brake (EPB)
Transmission control unit - Gear selector
position (automatic transmission)
Trailer module - Trailer connection status
The parking aid module carries out self-check
routines and when the parking aid is active, checks
the parking aid sensor wiring for short or open
circuits. If a concern is detected, a diagnostic
trouble code (DTC) is stored in a memory in the
parking aid module and the front and rear parking
aid sensors will be disabled until the DTC is cleared
and the ignition cycled. The driver is made aware
of any concern condition by the parking aid switch
LED flashing and a continuous high pitch warning
tone being emitted for 3 seconds when the parking
aid is activated, in place of the normal short tones
when the parking aid is functioning normally. DTCs
can be read using the Ford approved diagnostic
tool through the data link connector (DLC).
For additional information, refer to: Parking Aid
Module (413-13 Parking Aid, Removal and
Installation).