Reparos localizados

501-36-54 Paint - General Information 501-36-54 DESCRIPTION AND OPERATION Rubbing down TO BE UPDATED LATER The repair location is now rubbed down with P400 - P500 and the bordering surface with P2000 - P4000. Remove sanding residues and clean the repair area with silicone remover. Paint TO BE UPDATED LATER Before painting, clean the area for the final time using a dust-bonding cloth. Then apply the basic paint in thin layers using a spray gun until enough coverage is achieved. After drying, apply clear lacquer in 1 or 2 coats (depending on product). In doing so, spray so that only the newly applied basic paint is completely covered. Finally a touch-up thinners is sprayed over the edge of the clear lacquer to dissolve the clear lacquer spray mist. Dry TO BE UPDATED LATER Now dry the clear lacquer according to the manufacturer's instructions using an infrared gun. Polish TO BE UPDATED LATER Polish the component using a polisher and polish and check the polished area for any swirl marks which may be present. Polish away any swirl marks which are present. Dirt inclusions Sand out TO BE UPDATED LATER Minor damage can be removed with a small sanding machine or preferably with an eccentric sander with P1500 - P2000. Very fine spray mist