Inicialização do motor do vidro da porta

501-11-4 Glass, Frames and Mechanisms 501-11-4 GENERAL PROCEDURES Door Window Motor Initialization WARNING: The window anti-trap function will not operate during the window motor initialization procedure. NOTE: Make sure that the window runs are correctly installed and free of foreign material. NOTE: If the power to a window regulator motor has been disconnected, that window regulator motor must be initialized. NOTE: Wait for a minimum of 1 minute before connecting the battery, fuse or electrical connector. 1. Start the engine. 2. Press and hold the power window control switch close button until the door window is fully closed. 3. Release the power window control switch close button. 4. Press the power window control switch close button three times for one second. 5. Briefly press the power window control switch open button to the 2nd detent and release the button. The door window should open automatically. 6. Briefly press the power window control switch close button to the 2nd detent and release the button. If the door window does not close automatically, repeat the complete procedure. 7. Repeat the door window motor initialization for each door window motor. 8. Switch off the engine.