501-27 Funilaria dianteira

501-27-1 Front End Sheet Metal Repairs 501-27-1 . SECTION 501-27 Front End Sheet Metal Repairs VEHICLE APPLICATION: 2011.50 Ranger CONTENTS REMOVAL AND INSTALLATION Front Fender....................................................................................................................... Fender Apron Panel Reinforcement................................................................................... PAGE 501-27-2 501-27-4

501-27-2 Front End Sheet Metal Repairs 501-27-2 REMOVAL AND INSTALLATION Front Fender Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). 2. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation). 3. Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation). 4. E128828 5. E128788 6. Torque: 9 Nm E133768

501-27-3 Front End Sheet Metal Repairs 501-27-3 REMOVAL AND INSTALLATION 7. Torque: 9 Nm E133769 Installation 1. To install, reverse the removal procedure.

501-27-4 Front End Sheet Metal Repairs 501-27-4 REMOVAL AND INSTALLATION Fender Apron Panel Reinforcement General Equipment Air Body Saw Removal 1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). 2. Refer to: Front Fender (501-27 Front End Sheet Metal Repairs, Removal and Installation). 3. ‡ Partial Replacement ‡ Possible cut line. General Equipment: Air Body Saw E134921 4. ‡ Mill out the spot welds. General Equipment: Spot weld drill Bit E134919 General Equipment Spot weld drill Bit 5. ‡ Mill out the spot welds. General Equipment: Spot weld drill Bit E134920 Installation 1. NOTE: Before resistance spot welding of body panels with a total panel thickness of 3 mm and greater, the manufacturer's welding equipment instructions and sub-section 501-25 must be followed. Refer to: Tools and Equipment for Body Repairs (501-25 Body Repairs - General Information, Description and Operation). 2. NOTE: Sealer or adhesive must not be applied in welding zones. Areas which were bonded or sealed needs to be thoroughly sealed afterwards. Refer to: Sealer, Underbody Protection Material and Adhesives (501-25 Body Repairs - General Information, Description and Operation).

501-27-5 Front End Sheet Metal Repairs 501-27-5 REMOVAL AND INSTALLATION 3. ‡ Resistance spot weld - Panel thickness 3 mm and greater. E134922 4. ‡ Resistance spot weld - Panel thickness 3 mm and greater. E134923