Regulagem da folga de válvulas

303-01A-18 Engine – 2.5L Duratec-HE (122kW/165PS) - MI4 303-01A-18 GENERAL PROCEDURES NOTE: Mark the location and orientation of each camshaft bearing cap. 7 6 4 3 5 1 2 12 11 10 8 E134716 20. ‡ Remove the valve tappet and read the thickness from the underside. 21.NOTE: The number on the valve tappet only reflects the digits that follow the decimal. For example, a tappet with the number 0.650 has the thickness of 3.650 mm. NOTE: The nominal clearance is: intake: 0.25 mm (0.0095 in). exhaust: 0.30 mm (0.0115 in). NOTE: The acceptable clearances after being fully installed are: intake: 0.22-0.28 mm (0.008-0.011 in). exhaust: 0.27-0.33 mm (0.010-0.013 in). ‡ Calculate the required thickness of the valve tappet with the following formula: X S + M - V ‡ Required thickness of tappet ; ‡ Thickness of currently fitted tappet 6 ‡ Measurement of existing valve clearance (actual value) 0 ‡ Desired valve clearance 9 22.Install the correct valve tappet. 23. CAUTION: Make sure that the camshafts and camshaft bearing caps are installed in their original locations. NOTE: Lubricate the camshaft journals and bearing caps with clean engine oil. Coat the camshaft bearing caps with oil and install the camshafts approximately at valve overlap position cylinder No. 4. Material: Hypoid Oil 85W-90 (SQ-M2C9002-AA / A72SX-19K261-CA) transmission fluid Torque: ‡ Stage 1: 7 Nm ‡ Stage 2: 16 Nm 6 8 7 10 12 11 4 1 2 3 5 E134721 24.Special Tool(s): 303-465 303-465 E134694 25.Install the timing chain on the intake camshaft drive gear. E134715 26.NOTE: Only tighten the bolt finger tight at this stage.