Sangria do sistema de freios

Brake System - General Information 206-00-7 206-00-7 GENERAL PROCEDURES Brake System Bleeding(12 141 0) General Equipment Worldwide Diagnostic System (WDS) Bleeding All Vehicles WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes. Wash hands thoroughly after handling. If brake fluid contacts the eyes, flush the eyes for 15 minutes with cold running water. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury. CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. NOTE: Make sure that the vehicle is standing on a level surface. NOTE: The system consists of separate circuits for each front and diagonally opposite rear wheel. Each circuit can be bled independently. 1. CAUTION: The brake fluid reservoir must remain full with new, clean brake fluid at all times during bleeding. Install the bleed tube to the bleed nipple. 2. Immerse the end of the bleed tube in a bleed jar containing a small quantity of approved brake fluid. 3. Position the bleed jar base at least 300 mm above the bleed nipple to maintain fluid pressure and prevent air leaking past the threads of the bleed nipple. 4. Loosen the rear left bleed nipple by one-half turn. 5. Operate the brake pedal fully (pumping brake fluid and air into the bleed jar) and allow the brake pedal to return to the rest position. 6. NOTE: Rear brakes only. Rapidly operate the parking brake control several times. 7. Fill the brake fluid reservoir to the MAX mark. 8. Continue operating the brake pedal until air-free fluid is being pumped into the bleed jar. 9. With the brake pedal fully depressed tighten the bleed nipple. 10. CAUTION: Make sure that the bleed nipple cap is installed after bleeding the brake line(s). This will prevent corrosion to the bleed nipple. Failure to follow this instruction may result in the bleed nipple becoming seized. Repeat the procedure for the remaining brake lines in the following order: 1. Front left. 2. Front right. 3. Rear right. Vehicles with anti-lock brakes 11. NOTE: This step is only necessary when changing the brake fluid to remove the used brake fluid from the hydraulic control unit (HCU). Using WDS, bleed the brake system.