Funções controladas pelo módulo

419-10-5 Multifunction Electronic Modules 419-10-5 DESCRIPTION AND OPERATION calculation will not result in the lights being switched on. Headlamp switch-off delay The headlamp switch-off delay utilizes the low beam together with the peripheral lights (if equipped) to illuminate the area surrounding the vehicle. The function is activated by operating the high beam lever when the ignition switch is in the "0" position and the light switch is in the "AUTO" position. After the last door has been closed, the function remains active for a further 30 seconds and then switches off automatically. When a door or the tailgate is open, the switch-off time is extended to 180 seconds. After the last door has been closed, the switch-off time is reset to 30 seconds. The headlamp switch-off delay can be deactivated prematurely by operating the high beam lever again or by switching on the ignition. The switch-off time is set to the above values at the factory, and can be changed in the central module configuration by a Ford dealer. Interior lighting Depending on the vehicle specification, the interior lighting which is controlled by the BCM may include: ‡ Left and right-hand footwell lamps ‡ Front and rear dome lamps (in "door contact" switch position) Depending upon vehicle specification, the interior lamps which can be switched by the operator include: ‡ Front and rear dome lamps (in "On" switch position) ‡ Map lights ‡ Glove compartment lamp The BCM-controlled interior lighting is switched on with dimmed brightness if one of the following conditions is satisfied: ‡ One of the vehicle's doors is opened. ‡ The ignition key is in the "0" or "I" position and the vehicle is unlocked. ‡ The ignition key is turned from the "II" to the "I" or "0" position. The BCM-controlled interior lighting is switched off if all of the doors are closed and one of the following conditions is satisfied: ‡ 25 seconds have elapsed since the last door was closed. ‡ The ignition key is turned from the "0" or "I" to the "II" position. ‡ The ignition key is in the "0" or "I" position while the vehicle is locked. The duration of the dimmer function is 1.7 seconds in both the switch-on and switch-off phases. The dimmer function is not used if the interior lighting is switched off by the battery saving function after 30 minutes. Heated windscreen The heated windshield is switched on by the BCM under the following conditions: ‡ The heated windshield switch is operated, the ignition switch is in position "II" and the charge warning lamp is switched off. ‡ The "Defrost" function of the climate control has been activated, the ignition switch is in position "II" and the charge warning lamp is switched off. The heated windshield is switched off by the BCM under the following conditions: ‡ More than 4 minutes have elapsed since the switch for the heated windshield was operated. ‡ The engine is switched off. ‡ The "Defrost" function is deactivated or the switch for the heated windshield is pressed again while the heated windshield is still switched on. ‡ The charging system warning indicator is switched on. ‡ The battery voltage has dropped below 10.3 V for more than 20 seconds (power management strategy). Manual requests for switching on the heated windshield by pressing the switch, are ignored at this time. If the battery voltage returns to the normal range then the disabling of the heated windshield is cancelled - the heated windhsield is then in a switched-off state.