Acoplamentos de trava com mola

Fuel System - General Information – 2.5L Duratec-HE 310-00A-7 310-00A-7 (122kW/165PS) - MI4 GENERAL PROCEDURES Spring Lock Couplings Activation WARNINGS: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury. Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury. Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury. When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury. Remove the fuel filler cap slowly. The fuel system may be under pressure. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Otherwise, fuel may spray out. Failure to follow these instructions may result in serious personal injury. NOTE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is essential that absolute cleanliness is observed when working with these components or component damage may occur. Always install blanking plugs to any open orifices or tubes. NOTE: When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector retaining clip area before separating from the tube or damage to the tube or connector retaining clip may occur. Apply clean engine oil to the end of the tube before inserting the tube into the connector. NOTE: Fuel supply line connectors are color coded white. Fuel return line connectors are color coded red. 20.Refer to: Fuel System Pressure Release (310-00 Fuel System - General Information - 2.5L Duratec-HE (122kW/165PS) - MI4, General Procedures). 21.Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions (100-00 General Information, Description and Operation). 22.Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). 23.Refer to: Lifting (100-02 Jacking and Lifting, Description and Operation). 24.If equipped, remove the fuel tube safety clip. E131223 25. E131224