Manga de eixo – 2WD

Front Suspension 204-01-8 204-01-8 REMOVAL AND INSTALLATION Wheel Knuckle – 2WD(14 343 0) Special Tool(s) 211-020 Separator, Ball Joint 13005 49-T028-3A0 Remover, Ball Joint Puller Set E139377 Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTIONS: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts. Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while the vehicle is being serviced. Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation). 2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). 3. Torque: 7 Nm 2 1 E125403 4. WARNING: Make sure that no load is placed on the brake hose. Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation). 5. WARNING: Make sure that a new nut is installed.