Coluna B e reforço – Cabine dupla

501-29-49 Side Panel Sheet Metal Repairs 501-29-49 REMOVAL AND INSTALLATION Installation 1. NOTE: Before resistance spot welding of body panels with a total panel thickness of 3 mm and greater, the manufacturer's welding equipment instructions and sub-section 501-25 must be followed. Refer to: Tools and Equipment for Body Repairs (501-25 Body Repairs - General Information, Description and Operation). 2. NOTE: Sealer or adhesive must not be applied in welding zones. Areas which were bonded or sealed needs to be thoroughly sealed afterwards. Refer to: Sealer, Underbody Protection Material and Adhesives (501-25 Body Repairs - General Information, Description and Operation). 3. ‡ ‡ The holes need to be pre-milled with a spherical cutter with a small diameter. Afterwards these holes are then milled out to the required diameter with a spindle milling cutter. This method is essential in order to ensure that the material in the edge area of the milled holes is not weakened. Equipment: Spherical cutter ‡ Equipment: spindle milling cutter E140101